DNA Driveways Coventry logo
DNA Driveways Coventry Logo
Click to call DNA Driveways Coventry
Send a message to DNA Driveways Coventry

Driveway Sealing Coventry

Sealing for tarmac, concrete, imprinted concrete and block paving. Protection against water, frost, oil and weeds.

As DNA Driveways Coventry, part of DNA Landscapes, we seal the surfaces we lay. A sealed drive resists stains, keeps its colour and holds back moss and weeds, and it costs a fraction of resurfacing or replacing a drive that has been left to deteriorate.

Spreading black sealant across a tarmac driveway with a rubber squeegee

Google reviews

★★★★★ 5.0 on Google

Established

Part of DNA Landscapes since 2015

Accreditation

Tobermore registered contractor

Sealing

Priced on inspection

Why seal

What sealing does for a driveway

Keeps water out

Water in small cracks freezes, expands and breaks the surface up. Sealing stops it getting in.

Resists stains

Oil and other spills sit on the surface instead of soaking in, so they clean up far more easily.

Slows moss and weeds

Less for growth to take hold of means less cleaning through the year.

Brings colour back

Especially on imprinted concrete. On block paving, it also binds the joint sand.

How we seal tarmac and concrete

Clean, dry, then two coats

Pouring black sealant from a tub onto a tarmac driveway

The sealant is stirred, then poured

Spreading sealant across a tarmac drive with a squeegee beside a lawn edge

Spread evenly with a squeegee or roller

Close-up of sealant being worked into a tarmac surface with a squeegee

Worked into every pore

1

Clean

A thorough clean first, because sealing a dirty drive seals the dirt in.

2

Dry

A full day at least, more after rain or on thick concrete.

3

First coat

Applied mid-morning, before full sun, so it doesn’t dry too fast and streak. This coat soaks in.

4

Second coat

A lighter top coat, rolled in overlapping directions so nothing is missed.

Edges are cut in by brush to keep sealant off walls, kerbs and lawns. If the weather isn’t right on the day, we come back rather than do a poor job.

Block paving

Sealing block paving

Block paving is sealed differently. Because the joints will be re-filled, the clean can be more thorough. Once the blocks are completely dry, which can take a few days, kiln-dried sand is brushed into the joints. A thinner sealer is then sprayed on, with a second coat an hour or two later. It’s fine to walk on after a few hours, and we’ll tell you when it’s ready to drive on.

The sealer helps bind the joint sand in place, which keeps weeds down, and makes efflorescence, the white bloom that can appear on new blocks, less likely.

How often

When to seal each surface

SurfaceFirst sealThen re-seal
TarmacAt least 6 months after layingEvery 3–5 years
ConcreteAfter a couple of monthsAbout every 5 years
Imprinted concreteSealed when laidAbout every 4 years
Block pavingOptional, once settledAs it wears, after a clean and re-sand

For our own customers

A yearly visit to keep your seal fresh

Had your drive laid by us? Book it onto our annual clean and seal service and we’ll return every year to wash it down and renew the sealer, at a reduced rate for scheduled visits. This one is reserved for driveways DNA has installed.

Wondering whether your drive is due a seal? Ring us or message a picture and you’ll get a straight answer.

Questions

Driveway sealing questions

We leave it a full day as a minimum, more if it’s been damp. The surface must be completely dry, or the sealer won’t bond properly.

Tarmac, concrete, imprinted concrete and block paving, along with most porous paving stone used for patios.

Yes, a pressure wash will wear sealant away. That’s why any deep clean should be followed by re-sealing soon afterwards.

You can usually walk on it after a few hours. We’ll tell you when it’s ready for cars, which depends on the sealer and the weather.

Sealing costs far less than resurfacing or replacing a drive damaged by water and frost, and it makes day-to-day cleaning much easier.

If we laid your drive, yes: our yearly clean and seal visits come at a reduced rate. It isn’t offered for drives laid by others.

Areas we cover

Sealing drives across Coventry and the surrounding towns

Coventry
Kenilworth
Balsall Common
Rugby
Cawston
Long Lawford
Nuneaton
Bedworth
Bulkington
Hinckley

Our driveway services

Book driveway sealing

Ring 0247 542 6111. We’ll look at the surface, clean it if it needs it, and seal it when the weather is right.

© 2026   All Rights Reserved | DNA Landscapes (Coventry) Ltd Trading as DNA Driveways Coventry - Company Reg. 15642463

DNA Driveways logo

Founded by Andy Lyden groundwork specialist since 2008

Business Hours

DNA Driveways certification as a Tobermore registered paving contractor